Toshiba E-STUDIO5506AC - Page 222

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-86
3. Printer-specific Adjustments
To adjust the image quality on Black and White printing
("Black and White" is selected from among the "Color" options on the PCL6 or PS3 or XPS printer driver.
"Mono" is selected from among the "Color Type" options on Macintosh.)
* The "Color" options are available in the "Basic" tab on the PCL6, PS3 and XPS printer drivers. The
"Color Type" options are available in the "Color Settings 1" menu in the print dialog box on Macintosh.
(a) Select [05 ADJUSTMENT MODE]. Increase the value for codes [7307] or [7302] to adjustment the upper
limit of the image density in the toner save mode.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Resolution PDL [05] code Subcode
Recommended
value
Acceptable
value range
Default
600dpi
PS3 05-7307 0
Set a value smaller
than 176 to decrease
the density.
Set a value larger
than 176 to increase
the density.
0 to 255 176
PCL6 05-7307 1
XPS 05-7307 2
1200dpi PS3 05-7302 0
Set a value smaller
than 176 to decrease
the density.
Set a value larger
than 176 to increase
the density.
0 to 255 176
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.

Caution after the adjustment
The adjustment may possibly cause an increase of the amount of toner used (if the image density is increased) or provide
faint print images (if the image density is decreased). Therefore, carefully perform the adjustment, while checking the
printouts.