Toshiba E-STUDIO5506AC - Displaying the preview of a received fax

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 7
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
It is recommended that the changing amount for one time falls within ± 20 bits.
(b) Select [05 ADJUSTMENT MODE], select code [2742] and then press the [START] button.
After performing image quality control, print the image and check its quality on the solid areas.
(2) Select [08 SETTING MODE]. Change the value to adjust the density of a solid area during the
copying/printing operation.
• Use steps (a) to (b) to perform the adjustment.
(a) Select [08 SETTING MODE]. Change the values for codes [2513/2514] to adjust the developer
bias output value.
* The value to use varies depending on the paper type and color to adjust. Check the code to use in
accordance with the following "Code" list, and refer to the "Value" list to select a proper value.
Paper type
Color to adjust
[08] code
Subcode
Except
extra long
size paper
Plain / Recycled /
Thick
Y (yellow)
08-2513
0
M (magenta)
1
C (cyan)
2
K (black)
3
Other
Y (yellow)
08-2514
0
M (magenta)
1
C (cyan)
2
K (black)
3
Extra long size paper*
Y (yellow)
08-2514
0
M (magenta)
1
C (cyan)
2
K (black)
3
* The table below shows you the acceptable paper weight for the paper type.
Paper type
Acceptable paper weight
Plain/Recycled
60 to 80 g/m²
Max. 60 lb. Cover
Thick
81 to 105 g/m²
Max. 110 lb. Index