Toshiba E-STUDIO5506AC - Page 239

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-103
3. Printer-specific Adjustments

Procedures
* The service technician must perform all adjustments.
* This adjustment will have an effect only on Auto or Color mode printing.
(1) Select [05 ADJUSTMENT MODE]. Decrease the values for codes [8070/8071] or [8089/8090] to reduce
the limit value of the maximum amount of toner used.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and Halftone).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Resolution Halftone
[05]
Code
Subcode
Recom
mended
value
Acceptable
value
range
Default
600dpi
Smooth 05-8071 0~8,11,12
Set a
value
smaller
than the
default.
0 to 255 128
Detail 05-8070 0~8,11,12
1200dpi
Smooth 05-8090 0~8,11,12
Set a
value
smaller
than the
default.
0 to 255 128
Detail 05-8089 0~8,11,12
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.
Subcode
Paper type
0
Plain paper
1
Thick
2
Recycled paper
3
Thick 1
4
Thick 2
5
Thick 3
6
Thick 4
7
Special 1
8
Special 2
11
Envelope
12
OHP

Caution after the adjustment
The adjustment may possibly cause dark areas such as shades on photo images to look unnaturally faint.
Therefore, carefully perform the adjustment, while checking the printouts.
PCL6
PS3
Mac
XPS