e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
3-148
3. Printer-specific Adjustments
* Once the "Enable adjustment of image position for duplex" check box is selected, the result of this
adjustment will be reflected to the printing.
(4) While checking with the equipment, perform the adjustment.
(f) Place the paper to be adjusted in the drawer. Carry out duplex printing using the printer driver.
* Make sure that the "Enable adjustment of image position for duplex" check box has been selected.
(g) Measure the amount of the deviation in the end edge of the front and back sides in the primary and
secondary scanning directions.
To Next Page
Loading...
