GENERAL PRECAUTIONS REGARDING THE SERVICE
The installation and service shall be done by a qualified service technician.
1. Transportation/Installation
- When transporting/installing the equipment, employ two or more persons and be sure to move it by
the casters while lifting the stoppers.
The equipment is quite heavy and weighs approximately Approx. 213 kg (469.6 lb.), therefore pay full
attention when handling it.
- Be sure not to hold the movable parts or units (e.g. the control panel, ADU or DSDF) when
transporting the equipment.
- Be sure to use a dedicated outlet with AC 120 V / 20 A, 220-240 V / 10 A for its power source.
- The equipment must be grounded for safety.
- Select a suitable place for installation. Avoid excessive heat, high humidity, dust, vibration and direct
sunlight.
- Provide proper ventilation since the equipment emits a slight amount of ozone.
- To insure adequate working space for the copying operation, keep a minimum clearance of 30 cm
(11.8”) on the left, 80 cm (32”) on the right and 10 cm (4”) on the rear.
- The equipment shall be installed near the socket outlet and shall be easily accessible.
- Be sure to fix and plug in the power cable securely after the installation so that no one trips over it.
- If the unpacking place and where the equipment is to be installed differ, perform image quality
adjustment (automatic gamma adjustment) according to the temperature and humidity of the place of
installation and the paper to be used.
- When the equipment is used after the option is removed, be sure to install the parts or the covers
which have been taken off so that the inside of the equipment is not exposed.
- When the LAN cable, USB cable or telephone line is connected, be sure to wire the cable or line by
passing it through the clamp of the rear cover.
Otherwise, they will be caught when the duplexing unit is opened/closed and thus may be damaged.
2. General Precautions at Service
- Be sure to turn the power OFF and unplug the power cables during service (except for the service
should be done with the power turned ON).
- Unplug the power cable and clean the area around the prongs of the plug and socket outlet once a
year or more. A fire may occur when dust lies on this area.
- When the parts are disassembled, reassembly is the reverse of disassembly unless otherwise noted
in this manual or other related documents. Be careful not to install small parts such as screws,
washers, pins, E-rings, star washers, harnesses in the wrong places.
- Basically, the equipment should not be operated with any parts removed or disassembled.
- The PC board must be stored in an anti-electrostatic bag and handled carefully using an antistatic
wrist strap since the ICs on it may be damaged due to static electricity.
To Next Page
Loading...
Need help?
General
