Toshiba E-STUDIO5506AC - Page 42

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 26
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Pattern B for out-of-registration colors
(7) Finely adjust the rotating speed of the fuser motor, in accordance with a pattern for the out-of-registration colors.
•Use steps (a) to (b) to perform the adjustment.
(a) Select code [4529]. Finely adjust the rotating speed of the fuser motor.
• Adjust the values in accordance with a pattern for the out-of-registration colors as shown in the table
below.
Pattern for
out-of-
registration
colors
[05] code Subcode Recommended value
Acceptable
value range
Default
Pattern A
05-4529 4
123 to 127
(Set a value smaller than the
current value)
0 to 255 128
Pattern B
129 to 133
(Set a value larger than the
current value)
(b) Select code [104], and then press [TEST PRINT]. Check all the patches on the second page of the
printed test print pattern to check whether the misaligned colors have been improved.
Paper feeding speed
slower than transfer belt
rotating speed
Paper feeding direction
Page 1
Patch eliminated at
the leading edge