e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-13
2. Copier-specific Adjustments
(2) Perform hue adjustment to adjust the tint of the color in the color area to change.
• Use steps (a) through (d) to perform the adjustment.
(a) Press [IMAGE] on the Control Panel.
(b) Press [HUE].
(c) Press [+] or [-] on the indicator of the color to adjust.
* Pressing [+] or [-] on the indicator changes the hue as shown below.
(For instance, press [+] at R (Red). Then the tint of R (Red) is closely matched with that of Y (Yellow). Press [-] at
R (Red). Then the tint of R (Red) will be closely matched with that of M (Magenta).
(d) Press [ENTER].
After adjusting the hue, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(3) Perform color balance adjustment or RGB adjustment to adjust the tint of colors in general.
• Use steps (a) through (d) to perform the adjustment.
(a) Press [IMAGE] on the Control Panel.
(b) Press [COLOR BALANCE] to adjust the color balance by changing the amount of toner (C, M, Y
and K) or [RGB ADJUSTMENT] to adjust the color balance by changing the intensity of R, G and B.
(c) Press [+] to enhance the tint of the color or [-] to decrease it.
* After selecting the color balance by changing the amount of toner (C, M, Y and K), press
[DETAIL]. The tint of the color can be adjusted according to density area (low-, medium- or high-
density area).
(d) Press [ENTER].
After adjusting the tint of the colors, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
To Next Page
Loading...
