e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-25
2. Copier-specific Adjustments
(2) Select [05 ADJUSTMENT MODE]. Change the values for the following codes below to adjust the density
level of the background.
* The highlighted area will become highly visible, if the background density is increased.
Color mode Original mode [05] code Recommended value
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
<Note> “Making the highlighted area more visible (or increasing the background density)” and
“eliminating the background color (or decreasing the background density)” are mutually
contradictory. If the background color is darkened to make the highlighted area more visible,
the hue of the background may change.
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(3) Press [BASIC] on the Control Panel. Press [ ] to increase the copy density.
After increasing the copy density, copy and check the copy image quality.
With the copy density set to the maximum, if further image quality adjustments are still necessary, the
service technician must use the next procedure.
(4) Select the User custom mode and select [05 ADJUSTMENT MODE]. Change the setting value for the code
[7690] to change the reproduction level of the background.
* For the User custom mode, refer to the procedures in “2.18.2 To Adjust Custom Mode Settings in Full Color Mode”.
To Next Page
Loading...
