Toshiba E-STUDIO5506AC - Page 86

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-40
2. Copier-specific Adjustments
(1) Press [BASIC] on the Control Panel and select the original mode option, as follows:
• To copy in the Full color or the Auto color mode: Select the Printed image mode option.
• To copy in the Black mode: Select the Photo mode option.
* To have the above original mode options selected by default, use the following procedures:
To change the default original mode on the Control Panel
Use steps (a) to (d) to change default original mode.
(a) Press [USER FUNCTIONS] on the Control Panel to enter the “User Functions” menu.
(b) Press [USER].
(c) Press [COPY].
(d) In the “ORIGINAL MODE FOR COLOR” or “BLACK” option, press the button corresponding to
the desired original mode option.
To change the default original mode in [08 SETTING MODE]
Select [08 SETTING MODE]. Change the value for code [9970] or [9976] to change the original mode
option, which is selected by default at power-on.
• In the Black mode
Value for 08-9970
Default original mode at power-on
0
Text/Photo (default)
1
Text
2
Photo
3
Image smoothing
4
User custom
• In the Full color mode
Value for 08-9976
Default original mode at power-on
0
Text/Photo (default)
1
Text
2
Printed image
3
Photo
4
Map
5
User custom
6
Read seal color
* Press [BASIC] on the Control Panel. Select “Custom” from among the original mode options in the Black
or the Full color mode.
If [Custom] is not displayed on a menu to select an original mode, enable the User custom mode by
referring to Chapter 2.18.
After changing the default original mode option, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.