Toshiba E-STUDIO5506AC - Setting Home Data Synchronization

e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
2-47
2. Copier-specific Adjustments
(1) Press [BASIC] on the Control Panel and select the original mode option, as follows:
• To copy in the Full color or the Auto color mode: Select the Printed image mode option.
• To copy in the Black mode: Select the Photo mode option.
* When copying a photo image in the Full color mode, select the Photo mode option from among the original
mode options.
* To have the above original mode options selected by default, refer to 2.18 To Program Frequently Used
Copy Settings (To Use Custom Mode).
After changing the default original mode option, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(2) Press [IMAGE] on the Control Panel. Press [SHARPNESS].
Press [SOFT] to soften the copy image.
After softening the copy image, copy and check the copy image quality.
If further image quality adjustment is necessary, go to the next step.
(3) Select [05 ADJUSTMENT MODE]. Change the values for codes [7056] to [7058], [7061], [7249] and [7794]
to [7800] to adjust the default value for the sharpness intensity.
* Decreasing the sharpness intensity will minimize the edges of the image.
Color mode Original mode [05] code
Recommended
value
Accepta
ble value
range
Default
Black
Text / Photo
05-7056
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
Text
05-7057
Photo
05-7058
User custom
05-7249
Image smoothing
05-7061
Full color
Text / Photo
05-7796
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
Text
05-7797
Printed image
05-7798
Photo
05-7799
Map
05-7800
User custom
05-7795
Red seal color
05-7794