124 HX7+ ASD Installation and Operation Manual
Preset Speed #10
Program Pattern Run Preset Speeds
This parameter assigns an output frequency to binary number 1010 and is
identified as Preset Speed #10. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see F018 for further information
on this parameter).
Direct Access Number — F289
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed #11
Program Pattern Run Preset Speeds
This parameter assigns an output frequency to binary number 1011 and is
identified as Preset Speed #11. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see F018 for further information
on this parameter).
Direct Access Number — F290
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed #12
Program Pattern Run Preset Speeds
This parameter assigns an output frequency to binary number 1100 and is
identified as Preset Speed #12. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see
F018 for further information
on this parameter).
Direct Access Number — F291
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed #13
Program Pattern Run Preset Speeds
This parameter assigns an output frequency to binary number 1101 and is
identified as Preset Speed #13. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see F018 for further information
on this parameter).
Direct Access Number — F292
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed #14
Program Pattern Run Preset Speeds
This parameter assigns an output frequency to binary number 1110 and is
identified as Preset Speed #14. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see F018 for further information
on this parameter).
Direct Access Number — F293
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
Preset Speed #15
Program Pattern Run Preset Speeds
This parameter assigns an output frequency to binary number 1111 and is
identified as Preset Speed #15. The binary number is applied to S1 – S4 of the
Terminal Board to output the Preset Speed (see F018 for further information
on this parameter).
Direct Access Number — F294
Parameter Type — Numerical
Factory Default — 0.00
Changeable During Run — Ye s
Minimum — Lower Limit (F013)
Maximum — Upper Limit (F012)
Units — Hz
F289 F294
To Next Page
Loading...
