HX7+ ASD Installation and Operation Manual 85
ST Input Terminal Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the ST input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable ST terminal to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F113
Parameter Type — Selection List
Factory Default — Standby
Changeable During Run — No
RES Input Terminal Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the RES input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable RES terminal to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F114
Parameter Type — Selection List
Factory Default — Reset
Changeable During Run — No
S1 Input Terminal Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the S1 input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S1 terminal to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F115
Parameter Type — Selection List
Factory Default — Preset Speed Cmd #1
Changeable During Run — No
S2 Input Terminal Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the S2 input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S2 terminal to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F116
Parameter Type — Selection List
Factory Default — Preset Speed Cmd #2
Changeable During Run — No
S3 Input Terminal Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the S3 input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S3 terminal to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F117
Parameter Type — Selection List
Factory Default — Preset Speed Cmd #3
Changeable During Run — No
S4 Input Terminal Assignment
Program Terminal Selection Input Terminals
This parameter selects the functionality of the S4 input terminal.
In addition, the input terminal must be specified as Normally Open or
Normally Closed.
This parameter sets the programmable S4 terminal to 1 of the 68 possible
functions that are listed in
Table 14 on pg. 189.
Direct Access Number — F118
Parameter Type — Selection List
Factory Default — Emergency Off
Changeable During Run — No
F113 F118
To Next Page
Loading...
