2.5 Installing / Uninstalling the Module
Unified Controller nv series type2 light Controller Unit Instruction Manual
31
(6) Tighten the M4 screw at the top of the mounting
hole to secure the module to the base unit.
Press the upper and lower parts of the module
with both hands until it is locked in the base unit.
(Recommended tightening torque: 1.47 N
・
m =
15 kgf
・
cm)
(7) Check that the orange lock is completely set.
(8) Connect the required cables.
Remark
(1) Remove the connector cover, provided at the factory for shipment, to connect the
cable.
Lock
To Next Page
Loading...
