Toshiba nv Series - Page 50

Chapter 2 Installing/Uninstalling
6F8C1575
32
■Procedure to install the power module
(1) Turn off the power of the type2 light controller.
Also turn off the external power supply to the I/O module.
(2) Mount the base unit on the vertical panel of the control board.
(Refer to 2.4 “Installing the Base Unit.”)
(3) Confirm the slot for mounting the base unit of the module.
(Refer to Figure 2-4 Module slots.) 
(4) Align the leads of the module to the upper
and lower slot guides of the base unit.
(5) Hold the upper and lower parts of the
module and press the module into the
perpendicular base unit slowly and
securely until the upper and lower lock
levers are set on the base (a clicking
sound is heard when the module is
locked).
(6) Tighten the M4 screw at the top of the
mounting hole to secure the module to the
base unit. 
(Recommended tightening torque: 1.47 N ・
m = 15 kgf ・ cm)
S
lot guides
Leads of the module
