2.5 Installing / Uninstalling the Module
Unified Controller nv series type2 light Controller Unit Instruction Manual
33
(7) Remove the module cover and open the terminal block cover. The handling of the
cover differs depending on the module. Refer to ■ Basic procedure to install/remove
the module cover.
(8)
Connect the required cables. Use a sheath crimping terminal for terminating the
cable.
(9)
Check proper connection and termination before mounting the module cover and
close the terminal block cover.
Remark
(1) After mounting the module on the base by fastening the screw, secure the base during
transportation and storage so that the module can be installed vertically.
To Next Page
Loading...
