4.4 Speaker Cover and Keyboard 4 Replacement Procedures
Installing the Speaker Cover and Keyboard
Install the speaker cover and keyboard according to the following procedures and Figure 4-
12, 4-13.
1. Connect the keyboard cable to CN12 on the system board.
2. Secure the keyboard with two M2.5x2.6 black bind screws.
3. Place the speaker cover in the correct position and secure the following 13 latches, in
that order:
- five bottom latches
- two right and left latches
- Six front latches
Qosmio F40/F45 Maintenance Manual 4-29
To Next Page
Loading...
