4.8 Robson Card 4 Replacement Procedures
Installing the Robson Card
Install the Robson card according to the following procedures and Figure 4-17.
1. Insert the Robson card into the connector an angle of 45 degrees.
2. Press down on the Robson card to secure it with two M2x4 white bind screws.
CAUTION: Do not touch the connectors on the Robson card and in the computer with
your bare hands. Robson card can fail if they are contaminated with sweat, natural oils,
etc. from your hands.
Qosmio F40/F45 Maintenance Manual 4-37
To Next Page
Loading...
