- 7 -
7.4 WEB PRINTER SPECIFICATIONS
This section describes the Web printer specifications using sample display files (*.htm, *.asp).
7.4.1 Setup
(1) To enable the Web printer function, the HTML files must be installed in the ATA card.
The procedure for installation is as follows:
c Insert the ATA card into the PC card slot if the notebook computer is used, or into the PC
card adapter if the desktop computer is used.
d After the ATA card is recognized and the drive is assigned, create the “SX_HTM” folder at
the root level, and create the folder “TMP” under the level of “SX_HTM”.
e Copy the display files (*.htm, *.asp) into the folder “SX_HTM”. There are 16 display files.
The “TMP” folder is used to store the temporary files.
f Confirm that the PC card can be removed safely, and then remove the ATA card.
To install display files, the FTP function is also available. For more details, refer to chapter 9
“FTP SERVER”.
(2) Insert the ATA card and the LAN card into Slot 1 and Slot 2 on the PCMCIA board,
respectively.
(3) Set the web printer function to ON in the system mode. For details on this procedure, refer to
the Key Operation Specification (TAA-1379).
NOTE: After the display files (*.htm) are copied into the ATA card, check the file attributes. If
“Read-only” is checked, it should be unchecked. If the file attribute is “Read-only”, the
Web function does not work properly.
To Next Page
Loading...
