Toshiba TEC B-SX4T - Watching the Printer Status

- 9 -
7.4.3 Watching The Printer Status
Select the menu on the left of the window.
c PRINTER STATUS: Indicates the printer state.
(The display is updated every 3 seconds.)
• IDLE HEAD CLOSE (The printer is in an idle state, and the head is closed.)
• IDLE HEAD OPEN (The printer is in an idle state, and the head is opened.)
• PRINTER WORKING (The printer is operating.)
• PRINTER PAUSE (The printer is in a pause state.)
• WAITING FOR PEEL OFF (The printer is waiting for a strip issue.)
• SYNTAX ERROR (A command syntax error occurred.)
• COMMUNICATION ERROR (A communication error occurred.)
• PAPER JAM (A paper jam occurred.)
• CUTTER ERROR (A cutter error occurred.)
• NO PAPER (The paper has run out.)
• NO RIBBON (The ribbon has run out.)
• HEAD OPEN ERROR (Head open error occurred.)
• THERMAL HEAD ERROR (Broken dots head error occurred.)
• EXCESS HEAD TEMPERATURE (The head temperature is excessively high.)
• RIBBON ERROR (Ribbon error occurred.)
• REWINDER OVERFLOW (Rewinder overflowed)
• FLASH SAVE MODE (In the save mode)
• FLASH WRITE ERROR (A writing error occurred.)
• FLASH ERASE ERROR (An erasing error occurred.)
• FLASH MEMORY FULL (The remaining capacity is not sufficient.)
d RIBBON STATUS: Indicates the length of used ribbon.
(The display is updated every 3 seconds.)
• RIBBON 1/8 (The used ribbon length is 1/8 of total length.)
• RIBBON 2/8 (The used ribbon length is 2/8 of total length.)
• RIBBON 7/8 (The used ribbon length is 7/8 of total length.)
• RIBBON 8/8 (The used ribbon length is 8/8 of total length.)
e PAPER SENSOR: Indicates the level of the paper sensor.
(The display is updated every 3 seconds.)
• TRANSMISSIVE SENSOR: ∗.∗ V (Input level for the transmissive sensor: 0.0 V to 5.0 V)
• REFLECTIVE SENSOR: ∗.∗ V (Input level for the reflective sensor: 0.0 V to 5.0 V)
f HEAD UP SENSOR: Indicates the head up sensor status.
(The display is updated every 3 seconds.)
• HEAD CLOSED (The head is closed.)
• HEAD OPEN (The head is opened.)
g TEMPERATURE SENSOR: Indicates the temperature sensor status.
(The display is updated every 3 seconds.)
• HEAD TEMPERATURE: ∗∗ °C (Head temperature)
• OUTSIDE TEMPERATURE: ∗∗ °C (Outside air temperature)