Toshiba Tecra M3 - Wireless LAN Test Program (Intel-Made Calexico2 B;G)

3.27 Wireless LAN Test Program (Intel-made Calexico2 b/g) 3 Tests and Diagnostics
TECRA M3 Maintenance Manual (960-507) 3-63
3.27 Wireless LAN Test Program (Intel-made Calexico2 b/g)
This section describes how to perform the wireless LAN transmitting-receiving test. To execute the
wireless LAN test, use the Diagnostics disk for wireless LAN test. Finish the tests of the Main test
program by selecting 99 - EXIT TO DIAGNOSTICS MENU in the DIAGNOSTIC TEST
MENU. Then in the DIAGNOSTICS MENU, select 9 - EXIT TO MS-DOS.
Insert the Diagnostics disk for wireless LAN test into the Floppy Disk Drive. Turn on the power
while pressing U.
The following menu appears in the display.
******Intel Calexico 11b/g Card Maintenance test Menu*****
* *
* 1 : SKU check of Module *
* *
* 2 : MAC Address Check *
* *
* 3 : Antenna Check & communication test of 11b mode *
* *
* 4 : Communication test of 11g mode *
* *
* 5 : All the tests of Calexico 11g Card *
* (SKU & MAC Check, 11b/g communication test) *
* *
**********************************************************
SELECT TEST No. (1-5) :
To execute the subtest, input the subtest number and press Enter.
Subtest 01 SKU check of module
This subtest displays SKU information on the wireless LAN card installed. When
selecting this subtest, following message will appear in the display. Confirm if the
right information on the wireless LAN card is described.
************************************************************
* *
* Module : Intel Calexico 802.11b/g (MoW) *
* G-code : G36C0000X310 *
* PBA No. : C55369 *
* *
************************************************************
If a defective is found during the test, NG message will appear in the display.
Press any key to return to the test menu.