4 Replacement Procedures 4.24 Microphone / Wireless LAN antenna / Bluetooth antenna
4-78 TECRA M3 Maintenance Manual (960-507)
4.24 Microphone / Wireless LAN antenna / Bluetooth antenna
Removing the Microphone / Wireless LAN antenna / Bluetooth antenna
To remove the microphone / wireless LAN antenna / Bluetooth antenna, follow the steps below and
refer to Figure 4-52 and 4-53.
1. Remove the hinge cap (right).
2. Peel off the aluminum tape and five acetate tapes.
3. Take out the microphone from the slot while passing the cable from the hole.
Figure 4-52 Removing the microphone
Hinge cap
Acetate tape
Acetate tape
Acetate tape
Microphone
Aluminum tape
To Next Page
Loading...
