4.16 LAN jack 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-51
4.16 LAN jack
Removing the LAN jack
To remove the LAN jack, follow the steps below and refer to Figure 4-31.
1. Peel off the glass tape on the LAN jack cable.
2. Disconnect the LAN jack cable from the connector CN4100 on the system board.
3. Remove the LAN jack from the slot.
Figure 4-31 Removing the LAN jack
Installing the LAN jack
To install the LAN jack, follow the steps below and refer to Figure 4-31.
1. Install the LAN jack to the slot.
2. Connect the LAN jack cable to the connector CN4100 on the system board.
3. Stick the glass tape on the LAN jack cable.
LAN jack
CN4100
LAN jack cable
Glass tape
To Next Page
Loading...
