Toshiba Tecra M3 - Slim Select Bay Module

4.6 Slim select bay module 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-19
4.6 Slim select bay module
Removing the Slim select bay module
To remove the slim select bay module, follow the steps below and refer to Figure 4-7 and 4-8.
CAUTION: The slim select bay module can become hot with use. Be careful when
removing the module.
1. Remove the following screw securing the latch and drive the removed screw into the screw
hole. (The slim select bay is unlocked.)
? M2.5?4B FLAT HEAD screw ?1
2. While sliding the latch toward the arrow direction in the figure, slide the slim select bay
module outward to disconnect it from the system board.
Figure 4-7 Removing the slim select bay module (for example DVD-ROM drive)
M2.5
?
4B FLAT HEAD
DVD-ROM drive
Latch Screw hole