4 Replacement Procedures 4.21 Speaker
4-62 TECRA M3 Maintenance Manual (960-507)
4.21 Speaker
Removing the Speaker
To remove the speaker, follow the steps below and refer to Figure 4-42.
1. Remove the following screws and the speaker holders and speakers (right and left).
? M2.5?6B FLAT HEAD screw ?2
Figure 4-42 Removing the speakers
2. Peel off the two acetate tapes and three insulators securing the speaker cable.
3. Remove the speaker cable from the slot.
M2.5?6B FLAT HEAD
M2.5?6B FLAT HEAD
Speaker holder
Speaker holder
Speaker
Speaker
Insulator
Insulator
Acetate tape
Insulator
Speaker cable
To Next Page
Loading...
