Toshiba Tecra M3 - LCD Unit;Fl Inverter

4 Replacement Procedures 4.23 LCD unit / FL inverter
4-66 TECRA M3 Maintenance Manual (960-507)
4.23 LCD unit / FL inverter
Removing the LCD unit / FL inverter
To remove the LCD unit / FL inverter, follow the steps below and refer to Figure 4-46 to
4-51.
1. Remove the two mask seals and the following screws securing the LCD mask.
? M2.5?6B FLAT HEAD screw ?2
Figure 4-46 Removing the mask seals and screws
M2.5?6B FLAT HEAD
M2.5?6B FLAT HEAD
Mask seal
Mask seal