Toshiba Tecra M3 - RGB Harness Holder; RGB Board; Modem Jack

4 Replacement Procedures 4.17 RGB harness holder / RGB board / Modem jack
4-52 TECRA M3 Maintenance Manual (960-507)
4.17 RGB harness holder / RGB board / Modem jack
Removing the RGB harness holder / RGB board / Modem jack
To remove the RGB harness holder / RGB board / modem jack, follow the steps below and refer
to Figure 4-32 to 4-34.
1. Remove the following screw securing the RGB harness holder.
? M2.5?4B FLAT HEAD screw ?1
2. Take out the RGB harness holder while unhooking the front latches.
Figure 4-32 Removing the RGB harness holder
M2.5?4B FLAT HEAD
RGB harness holder