Toshiba Tecra M3 - System Board; DC-IN Jack

4.20 System board / DC-IN jack 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-61
4 Replacement Procedures
4.20 System board / DC-IN jack
Removing the System board / DC-IN jack
To remove the system board / DC-IN jack, follow the steps below and refer to Figure 4-41.
1. Remove the following screw securing the system board.
? M2.5?4B FLAT HEAD screw ?1
2. Lift up the system board and DC-IN jack.
3. Disconnect the DC-IN jack cable from the connector CN8800 on the system board.
Figure 4-41 Removing the system board/DC-IN jack
Installing the System board / DC-IN jack
To install the system board / DC-IN jack, follow the steps below and refer to Figure 4-41.
1. Connect the DC-IN jack cable to the connector CN8800 on the system board.
2. Install the system board from the left side and secure it with the following screw.
? M2.5?4B FLAT HEAD screw ?1
3. Install the DC-IN jack into the slot.
M2.5?4B FLAT HEAD
System board
DC-IN jack
CN8800