4.2 Battery pack 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-9
4.2 Battery pack
Removing the Battery pack
To remove the battery pack, follow the steps below and refer to Figure 4-1.
CAUTION: When handling battery packs, be careful not to short circuit the terminals.
Also do not drop, hit or apply impact, do not scratch, break, twist or bend
the battery pack.
1. Turn off the power of the computer.
2. Disconnect the AC cable and other external devices from the computer.
3. Turn the computer face down.
4. Release the battery lock. Pull out the battery pack while sliding the battery latch.
NOTE: For environmental reasons, do not throw away a spent battery pack. Collect the
spent battery packs.
Figure 4-1 Removing the battery pack
Battery pack
Battery lock
Battery latch
To Next Page
Loading...
