Toshiba Tecra M3 - Cooling Fin; CPU

4.19 Cooling fin / CPU 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-59
4.19 Cooling fin / CPU
Removing the Cooling fin / CPU
To remove the Cooling fin / CPU, follow the steps below and refer to Figure 4-36 to 4-38.
CAUTION: 1) The CPU can become very hot during operation. Be sure to let it cool
before starting repair work.
2) When you remove the CPU, wipe the grease off of the bottom of the fin
and top of the CPU. Apply new grease when installing.
1. Remove the following screws securing the CPU holder, in the reverse order of the number
marked on the holder.
? M2?4Z BIND screw ?3
CAUTION: Remove the screws in the order of mark “3”, “2” and “1” on the CPU
holder.
2. Remove the CPU holder.
Figure4-36 Removing the CPU holder
M2?4Z BIND
CPU holder