Toshiba Tecra M3 - Bluetooth Test

3.29 LAN/Modem/Bluetooth/IEEE1394 Test Program 3 Tests and Diagnostics
TECRA M3 Maintenance Manual (960-507) 3-75
3.29.3 Bluetooth test
To execute this test, press 3 and press Enter.
Note: Use another computer that can communicate by the Bluetooth as a reference
machine to perform this test.
Insert a floppy disk containing the test program into the target machine and turn on the target
machine. The following Bluetooth test menu will appear.
#######################################################################
#### Bluetooth sub system test program VX.XX ####
#######################################################################
* *
* 1....BD_ADDR check *
* *
* 3... Communications test (DUT mode) *
* *
* T....communications test (TEST mode) *
* *
***********************************************************************
....Press test number [1, 3, T] ? _
Press 1 or 3 key to perform the corresponding subtest. To quit the Bluetooth test program, eject
the floppy disk and turn the computer off while the menu above is displayed.
Subtest 01 BD_ADDR check
This subtest checks the BD_ADDR functions. When the Bluetooth test menu is
displayed, press 1 to select the test and press Enter. The following message will
appear:
----------------------------------------------------------------------------
-
Bluetooth Subsystem T&D for PCSE(BD_ADDR) VerX.XX Copyright (C) by TOSHIBA
Co.
----------------------------------------------------------------------------
-
Initializing …