4.18 Fan 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-57
4.18 Fan
Removing the Fan
To remove the fan, follow the steps below and refer to Figure 4-35.
1. Remove the following screws securing the fan.
? M2.5?4B FLAT HEAD screw ?2
2. Peel off the glass tape and disconnect the fan cable from the connector CN8770 on the
system board.
3. Remove the fan.
Figure4-35 Removing the fan
M2.5?4B FLAT HEAD
Fan
Fan cable
CN8770
M2.5?4B FLAT HEAD
Glass
To Next Page
Loading...
