4.21 Speaker 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-63
Installing the Speaker
To install the speaker, follow the steps below and refer to Figure 4-42 and 4-43.
1. Install the speakers (right and left) to the slot.
2. Install the speaker holders (right and left) while inserting its tip to the slot and secure it with
the following screws.
? M2.5?6B FLAT HEAD screw ?2
3. Install the speaker cable to the slot while passing through the guide.
Figure 4-43 Installing the speaker cable
4. Stick three insulators to secure the speaker cable.
5. Stick two acetate tapes to secure the insulators and speaker cable.
Guide
Acetate tape
Insulator
Insulator
To Next Page
Loading...
