4 Replacement Procedures 4.5 HDD
4-18 TECRA M3 Maintenance Manual (960-507)
Installing the HDD
To install the HDD, follow the steps below and refer to Figure 4-4 to 4-6.
CAUTION: Do not hold the HDD by its top and bottom flat surfaces. It may damage the
HDD.
1. Attach the Guide mold to the HDD
2. Seat the HDD in the HDD bracket and secure them with the following screws.
? M3?4Z FLAT HEAD screw ?4
CAUTION: Do not apply pressure to the middle of the HDD pack. It may damage the
HDD pack. Hold the HDD pack by its corners.
3. Insert the HDD pack into the slot. Press to ensure a firm connection.
4. Seat the HDD cover and secure it with the following screw.
? M2.5?4B FLAT HEAD screw ?1
To Next Page
Loading...
