4 Replacement Procedures 4.15 RTC battery / HDD con holder
4-50 TECRA M3 Maintenance Manual (960-507)
2. Remove the HDD con holder.
Figure 4-30 Removing the HDD con holder
Installing the RTC battery / HDD con holder
To install the RTC battery/HDD con holder, follow the steps below and refer to Figure 4-29 and 4-
30.
1. Install the HDD con holder in position.
2. Install the RTC battery into the slot.
3. Connect the RTC battery cable to the connector CN9990 on the system board.
HDD con holder
To Next Page
Loading...
