4.15 RTC battery / HDD con holder 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-49
Removing the RTC battery / HDD con holder
To remove the RTC battery / HDD con holder, follow the steps below and refer to Figure
4-29 and 4-30.
1. Disconnect the RTC battery cable from the connector CN9990 on the system board and
remove the RTC battery from the slot.
Figure 4-29 Removing the RTC battery
RTC battery
CN9990
Slot
RTC battery cable
To Next Page
Loading...
