4 Replacement Procedures 4.5 HDD
4-16 TECRA M3 Maintenance Manual (960-507)
3. Pull the tab of the HDD pack to remove it from the system board. Be careful not to
damage the connector.
Figure 4-5 Removing the HDD pack
NOTE: The following steps describe how to disassemble the HDD pack, however, do not
disassemble if the HDD is working properly.
4. Place the HDD pack on a flat surface, and remove the following screws.
? M3?4Z FLAT HEAD screw ?4
5. Separate the HDD from the HDD bracket.
HDD pack
Tab
To Next Page
Loading...
