4.6 Slim select bay module 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-21
Installing the Slim select bay module
To install the slim select bay module, follow the steps below and refer to Figure 4-7 and 4-8.
1. Seat the plastic frame on the side of the slim select bay module, and secure it with the
following screws.
? M2?3S S-FLAT HEAD screw ?5
2. Install the connector and plastic brace and secure them with the following screws.
? M2?8S BIND screw ?2
3. Insert the slim select bay module into the computer to connect it to the connector on the
system board.
4. Secure the latch with the screw removed from the screw hole. (The slim select bay is
locked.)
? M2.5?4B FLAT HEAD screw ?1
To Next Page
Loading...
