4.8 Memory module 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-29
Installing the Memory module
To install the memory module, make sure that the computer is in boot mode and powered off,
follow the steps below and refer to Figure 4-14.
CAUTION: Do not install a memory module only in the upper slot for expansion. Use the
lower slot A prior to the upper slot. Otherwise, the computer or the memory
may be damaged.
Do not touch the connectors on the memory module or on the computer.
Dust and stains on the connectors may cause memory access problems.
1. Insert the memory module into the connector slantwise (terminal side first) and press it to
connect firmly.
CAUTION: The power must be turned off when you insert a memory module. Inserting a
memory module with the power on might damage the module or the
computer itself.
Never press hard or bend the memory module.
2. When the power of the computer is turned on, the computer checks automatically the
memory size. Confirm that the new memory is detected correctly.
3. If the memory is not detected, check that it is connected correctly.
To Next Page
Loading...
