4.9 Cover / Touch pad 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-33
Installing the Cover / Touch Pad
To install the cover/touch pad, follow the steps below and refer to Figure 4-15 to 4-20.
1. Connect the touch pad cable to the connector on the touch pad.
2. Install the touch pad and touch pad switch on the cover while hooking the latches.
3. Turn the cover face down and secure the touch pad and touch pad switch to the cover with
the following screws.
? M2.5?4B FLAT HEAD screw ?2
4. Place the cover on the display assembly and secure the latches by pressing it. Secure the
cover with the following screw.
? M2.5?4B FLAT HEAD screw ?1
? M2.5?12B FLAT HEAD screw ?2
5. Connect the touch pad cable to the connector CN3201 on the system board.
6. Close the display panel and turn the computer face down. Secure the cover with the
following screws to the display assembly.
? M2.5?4B FLAT HEAD screw ?1 (“4B” in the figure below)
? M2.5?6B FLAT HEAD screw ?7 (“6” in the figure below)
? M2.5?16B FLAT HEAD screw ?1 (“16” in the figure below)
? M2?4Z S-FLAT HEAD screw ?1 (“4” in the figure below)
or
? M2?4 Stick screw ?1 (“4” in the figure below)
To Next Page
Loading...
