4.11 Wireless LAN board 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-37
2. Press the latches outward to release the wireless LAN board.
3. Disconnect the wireless LAN board from the connector on the system board. Be careful
not to damage the connector.
Installing the Wireless LAN board
To install the wireless LAN board, make sure that the computer is in boot mode and powered off,
follow the steps below and refer to Figure 4-22.
CAUTION: Be sure to switch the computer off before installing the wireless LAN board.
Otherwise, the computer or the wireless LAN board may be damaged.
1. Insert the wireless LAN board into the connector on the system board.
2. Gently push the wireless LAN board down until the latches on both sides are engaged.
3. Connect the wireless LAN antenna cables (black and white) to the connectors on the
wireless LAN board and stick the glass tapes.
CAUTION: Stick the glass tape to the edges of the insulator shown below.
CAUTION: There are two MAC address barcode labels in the package containing the
new wireless LAN board. Apply one label on the wireless LAN board and one
on the box the computer was in. Before you apply the new labels, remove the
old ones from the wireless LAN board and the box. The computer may have
MAC address barcode labels for both wired and wireless LANs. Be sure to
replace the correct label.
Glass tape
Wireless LAN cable
To Next Page
Loading...
