4.13 Display assembly 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-41
2. Turn the computer face up and open the display.
3. Remove the following screw and the LCD cable holder.
? M2.5?6B FLAT HEAD screw ?1
4. Disconnect the LCD cable from the connector CN5500 on the system board.
5. Disconnect the power switch cable from the connector CN9600 on the system board.
6. Disconnect the RGB cable from the connector CN5621 on the system board.
7. Turn up the insulator and disconnect the speaker cable from the connector CN3202 on
the sound board.
8. Disconnect the microphone cable from the connector CN6001 on the sound board.
9. Disconnect the modem cable from the connector CN3001 on the system board.
10. Peel the insulator securing the wireless LAN cable.
Figure 4-25 Removing the display assembly (2)
LCD cable
RGB cable
Power switch cable
Insulator
Speaker cable
Microphone cable
LCD cable holder
M2.5?6B FLAT HEAD
Insulator
Modem cable
To Next Page
Loading...
