4.17 RGB harness holder / RGB board / Modem jack 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-55
Installing the RGB harness holder / RGB board / Modem jack
To install the RGB harness holder / RGB board / modem jack, follow the steps below and refer to
Figure 4-32 to 4-34.
1. Connect the RGB harness to the connector CN5622 on the RGB board.
2. Install the RGB board while inserting the RGB connector to the slot.
3. Secure the RGB board with the following screw.
? M2.5?2.8B FLAT HEAD screw ?1
4. Install the modem jack to the slot.
5. Stick the glass tape.
6. Install the RGB harness holder while hooking the front latches.
7. Secure the RGB harness holder with the following screw.
? M2.5?4B FLAT HEAD screw ?1
CAUTION: Route correctly the modem jack cable and RGB harness in the slot as shown
below.
Gasket
RGB harness
Modem jack cable
To Next Page
Loading...
