4.19 Cooling fin / CPU 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-61
Installing the Cooling fin / CPU
To install the Cooling fin / CPU, follow the steps below and refer to Figure 36 to 4-40.
1. Make sure the cam is in the open position.
2. Seat the CPU in the CPU socket. Make sure the alignment is exact to avoid damaging pins
on the CPU.
CAUTION: Place the CPU in such direction as shown below. (Pay attention to the
position of the triangle mark on the CPU.)
3. Fix the CPU by turning the cam on the CPU socket 180 degrees to the clockwise with a
flat-blade screwdriver (in the order shown in the figure below).
Figure 4-39 Installing the CPU
CPU CPU socket
Cam
Mark
To Next Page
Loading...
