4.23 LCD unit / FL inverter 4 Replacement Procedures
TECRA M3 Maintenance Manual (960-507) 4-73
Installing the LCD unit / FL inverter
To install the LCD unit / FL inverter, follow the steps below and refer to Figure 4-46 to
4-51.
1. Stick the aluminum cover on the LCD unit (only for the Samsung-made14.1-inch XGA
LCD unit).
CAUTION: When installing the LCD, be careful of the points in the following picture.
Align the edge of the
aluminum cover with
the corner of LCD unit.
Bend the aluminum
cover at these lines.
Back of the right side of LCD
Right side of LCD
Bend the aluminum cover to the side.
To Next Page
Loading...
