4 Replacement Procedure 4.26 Fluorescent Lamp
4-98 TECRA M3 Maintenance Manual (960-507)
Removing the screws
1. Remove the lamp clip (Reuse it).
2. Spread out the insulation sheet without detaching it from the side of the bezel, as shown in
Figure 4-70.
3. In the order (1) and (2) shown in Figure 4-70, remove the screws from the left- and right-
hand sides of the module.
CAUTION: (1) To unfasten the screws, use an insert bit of point size 0 for Philips
screwdrivers.
(2) Leave the insulation sheet on the bezel to allow the reuse of the sheet.
Figure 4-70 Replacing TMD fluorescent lamp (XGA) (2)
Product Label
Insulation sheet
Lamp clip
To Next Page
Loading...
