Toshiba Tecra M4 - Page 311

4 Replacement Procedure 4.32 Fluorescent lamp
Removing the bezel
1. Without removing the insulation tape, turn the face of module up.
2. Release the four latches of the bezel and frame (two positions on each side). With
holding up the bezel from the lower side (FL lamp side), release the three latches on
the top to remove the bezel from the cell. (The bezel is reused.)
CAUTION: 1. Do not damage the latches and FPC.
2. When removing the bezel, be careful not to deform the bezel.
Release the three latches on the top to remove the bezel from the cell.
Bezel
Release the
latches on the
side.
Release
the
latch on
the
side.
Hold up he lower side of bezel up.
Figure 4-51 Replacing 14.1 Inch TMD fluorescent lamp (3)
4-80 [CONFIDENTIAL] TECRA M4 Maintenance Manual (960-521)