Toshiba TOSVERT VF-PS1 - Page 199

E6581386
G-4
7
 Table of setting of contact input terminal function
Parameter setting Parameter setting
Positive
logic
Negative
logic
Function
Positive
logic
Negative
logic
Function
  No function is assigned   Trace back trigger signal
  F: Forward run command   No function assigned
  R: Reverse run command   No function assigned
  ST: Standby   No function assigned
  RES: Reset   Binary data write
  S1: Preset speed 1   Up/down frequency (up) *1
  S2: Preset speed 2   Up/down frequency (down) *1
  S3: Preset speed 3   Up/down frequency (clear)
  S4: Preset speed 4   Dancer correction OFF
  Jog run   No function assigned
  Emergency stop   Forward/reverse selection
  DC braking   Run/stop command *2
  Acceleration/deceleration switching 1   Commercial power/INV switching
  V/f switching signal 1   Frequency reference priority
switching
  PID control OFF selection   VI/II terminal priority
  External thermal error   Command terminal board priority
  Communication priority cancel   Permission of parameter editing *4
  HD operation retention   No function assigned
  PID differentiation/integration clear   No function assigned
  PID forward/reverse switching   No function assigned
  Forced continuous operation   No function assigned
  Specified speed operation   Rapidest deceleration command
  My function RUN signal   Preliminary excitation *3
  Auto-tuning signal   No function assigned
  Integrating wattmeter display clear   No function assigned
*1: Valid when  (Frequency setting mode selection 1) is set at  (External contact Up/Down).
The frequency setting range is between =~ (Upper limit frequency). The acceleration/deceleration time
with respect to the frequency setting remains /, unless switching between acceleration and
deceleration is performed.
*2: If ,  (F: Forward run command) or ,  (R: Reverse run command) is assigned at the same time, this
function has a priority.
*3: After the motor slows down and comes to a full stop at a pre-excitation command, the motor is set free
momentarily to bring it into a pre-excitation state.
This function should not be used when
 is set to  or . Or the inverter might malfunction.
*4: Do not set the function " Permission of parameter editing" into the parameter ~ (without option).
If it is set, cannot reset the setting. 
*5: Do not specify any number other than those listed in this table.
 Sink logic/source logic
Switching between sink logic and source logic (input/output terminal logic) is possible.
 For details, refer to the Section 2.3.2.