Toshiba TOSVERT VF-PS1 - Measures to Satisfy the EMC Directive

E6581386
I-2
9
9.1.2 Measures to satisfy the EMC directive
Concrete measures for EMC directive of CE markings are shown below.
 Models with a built-in EMC filter
(1) 200V class: VFPS1-2004PL~2075PL
400V class: VFPS1-4007PL~4630KPC
The above mentioned models install EMC noise filter inside. So the conducted and radiated noise can be reduced,
optional EMC noise filters are not needed.
(If a further noise reduction is required, insert an additional filter described in I-4 on the input side of the inverter.)
Table 2 EMC directive compliance
Requirements
Inverter type EMC plate type
PWM carrier
frequency
(kHz)
Length of
motor
connecting
cable
(m)
Conducted noise
IEC61800-3 category C2
(EN55011 classA Group1)
Conducted noise
IEC61800-3 category C3
(EN55011 classA Group2)
4 10 VFPS1-2004PL~
VFPS1-2015PL
EMP101Z
16 5
4 10
VFPS1-2022PL
16 5
Built-in filter -
4 10
VFPS1-2037PL
EMP102Z
16 5
4 10 VFPS1-2055PL,
VFPS1-2075PL
EMP103Z
16 5
- Built-in filter
4 10 VFPS1-4007PL~
VFPS1-4022PL
EMP101Z
16 5
4 10
VFPS1-4037PL EMP102Z
16 5
Built-in filter -
4 10 VFPS1-4055PL~
VFPS1-4110PL
EMP103Z
16 5
4 10
VFPS1-4150PL
16 5
2.5 25
VFPS1-4185PL
EMP104Z
16 25
2.5 50
VFPS1-4220PL EMP105Z
16 25
2.5 50 VFPS1-4300PL,
VFPS1-4370PL
EMP106Z
4 25
2.5 50 VFPS1-4450PL~
VFPS1-4750PL
EMP108Z
16 25
VFPS1-4900PC,
VFPS1-4110KPC
- 2.5 50
VFPS1-4132KPC - 2.5 50
VFPS1-4160KPC - 2.5 50
VFPS1-4220KPC - 2.5 50
VFPS1-4250KPC~
VFPS1-4315PL
- 2.5 50
VFPS1-4400KPC,
VFPS1-4500KPC
- 2.5 50
VFPS1-4630KPC - 2.5 50
- Built-in filter
( ): An optional regenerative braking unit PB7 is used.