E6581386
H-4
8
Input terminal information
Input terminal 1 (F) :
: 0
Input terminal 2 (R) :
: 1 When there is signal input
-: -: -
Input terminal 4 (RES) :
: 3 When there is no signal input
Input terminal 5 (S1) :
: 4 (blank in the upper half)
Input terminal 6 (S2) :
: 5
Input terminal 7 (S3) :
: 6
Input terminal 8 (RR/S4) :
: 7
Data bit of communication
No. FE06
Input terminal 9 (LI1) :
: 8 When there is signal input
Input terminal 10 (LI2) :
: 9
Input terminal 11 (LI3) :
: 10 When there is no signal input
Input terminal 12 (LI4) :
: 11 (blank in the upper half)
Input terminal 13 (LI5) :
: 12 When there is signal input
Input terminal 14 (LI6) :
: 13
Input terminal 15 (LI7) :
: 14 When there is no signal input
Input terminal 16 (LI8) :
: 15 (blank in the upper half)
Input terminal 9 to 16 : Expansion terminal board option unit
dd-on option
Output terminal information
Output terminal 1 (OUT1) :
: 1 When there is signal output
Output terminal 2 (OUT2) :
: 2
Output terminal 3 (FL) :
: 3 When there is no signal output
(blank in the upper half)
Data bit of communication
No. FE07
Output terminal 4 (OUT3) :
: 4
Output terminal 5 (OUT4) :
: 5
Output terminal 6 (R1) :
: 6 When there is signal output
Output terminal 7 (OUT5) :
: 7
Output terminal 8 (OUT6) :
: 8 When there is no signal output
Output terminal 9 (R2) :
: 9 (blank in the upper half)
Output terminal 10 (R3) :
: 10
Output terminal 11 (R4) :
: 11
Output terminal 4, 5, 6 (OUT3, OUT4, R1) :Expansion terminal board
option unit 1
Output terminal 7, 8, 9 (OUT5, OUT6, R2) :Expansion terminal board
option unit 2
Output terminal 10, 11 (R3, R4) :Not corresponding
dd-on option
Cumulative operation time
For indication of cumulative operation hours, running hours are counted up when the output frequency monitor
reads a frequency other than 0.0Hz. 10 hours is indicated as 0.1 (unit of Indication).
To Next Page
Loading...
