‘I-74
EFI SYSTEM - Fuel System
Fl169
ON-VEHICLE INSPECTlOiU
1.
INSPECT FUEL PUMP OPERATION
(a) Turn the ignition switch to ON. :
NOTE: Do not start the engine.
(b) Using a service wire, short circuit the fuel pump
check terminals +B and FP of the check connector.
CHECK CONNECTOR LOCATION:
See pages FI-1 10, 111
(c) Check that there is pressure in the fuel return hose.
NOTE: At this time, you will hear fuel pressure noise.
(d) Remove the service wire.
(el Turn the ignition switch OFF.
If there is no pressure, check the following parts.
i Fusible links
0 Fuse
0 EFI main relay
0 Fuel pump
0 Wiring connections
2. INSPECT FUEL PRESSURE
(a) Check that battery voltage is above 11 bolts.
(b) Disconnect the cable from the negative (-) terminal
of the battery.
(c) Remove the cold start injector tube.
(7M-GE)
0 Disconnect the wiring connector from the cold
start injector.
To Next Page
Loading...
Need help?
General
